Hydration mechanism of anhydrite and calcium sulfoaluminate co-activated slag cement: insights into the role of composition

Utilization of Portland cement to initiate the dissolution of blast furnace slag (BFS) in super-sulfated cement is limited by low slag substitution level and poor early strength. In this study, a new activator composed of anhydrite and calcium sulfoaluminate cement clinker was proposed to enhance the utilization of BFS in super-sulfated cement. Tests were conducted on the compressive strength, autogenous shrinkage, hydration heat, pH and conductivity of the composites. XRD, ²⁹Si NMR, BSE and MIP were employed. Results reveal that ettringite, gypsum and C-S-H are the primary hydration products. The composites with 20% activator display the highest compressive strength and shrinkage accompanied by the highest hydration heat and degree, as well as the highest quantity of monomer silica tetrahedrons and the largest volume of fine pores. Thermodynamic modeling confirms the critical value for the activator-substitution level. Additionally, the activator-BFS composite exhibited significantly lower carbon emissions compared to Portland cement.