Validation of decay heat calculation results of ORIGEN2.2 and CASMO5 for light water reactor fuel
Comparing with the fission product nuclide (FP) decay heat summation calculation result in MeV/sec/fission based on the JENDL FP decay and yield data files 2011 for the burst fission, FP decay heat calculated by ORIGEN2.2 coupled with JENDL-4.0 base library ORLIBJ40 was verified at the cooling time from 1 sec to 108 sec for 235U (thermal), 238U (fast), 239Pu (thermal) and 241Pu (thermal). For these fission nuclides, FP decay heat calculated by CASMO5 at the same cooling time after a short irradiation (104 sec) was also compared with that of ORIGEN2.2. In the analysis of decay heat measurements at the cooling time from 2.3 years to 27 years consisting of four data sets on the fuel assemblies discharged from the US PWRs and BWRs, and the Swedish PWRs and BWRs, the average values of the ratios of the calculated to measured results (C/E's) were from 0.972 to 1.031 for ORIGEN2.2, and from 0.977 to 1.016 for CASMO5. The standard deviations of C/E's for the four data sets were from 0.02 to 0.03 for the both codes except for those of the US BWR fuel assemblies which were from 0.11 to 0.12. The obtained C/E's were similar to those in the precedent study.