Glovebox laser cutting files

If this is your first time laser cutting, read this guide before you try to do anything. Remember to follow any local instructions and be safe.

These files are used for laser cutting the faces of the glovebox. You will need:

• 3mm plywood
• • 350x650mm (x3)
  • 350x350mm (x3)
• 3mm plexiglass - 350x650mm (x3)
• 2 door hinges
• A strong wood glue
• Masking tape
• Sandpaper

Optional:

• Bolts and nuts
• Corner brackets

Once cut, assemble the box as shown in the picture attached and apply wood glue to edges to bind the faces together. Meanwhile, use sandpaper to sand the surface of the hinges down then glue them to the lid and the top edge of the back face of the glovebox. You can choose to use bolts and nuts to secure them. Use masking tape to hold all components together as the glue dries.