TY - DATA T1 - Electrochemical Performance of Diamond Thin-Film Electrodes from Different Commercial Sources PY - 2004/05/01 AU - Anne E. Fischer AU - Yoshiyuki Show AU - Greg M. Swain UR - https://acs.figshare.com/articles/journal_contribution/Electrochemical_Performance_of_Diamond_Thin_Film_Electrodes_from_Different_Commercial_Sources/3340936 DO - 10.1021/ac035214o.s001 L4 - https://ndownloader.figshare.com/files/5180149 KW - Ru KW - Scanning electron microscopy KW - app KW - Different Commercial Sources KW - redox systems KW - Fe KW - type KW - Δ E p KW - i p ox KW - film KW - electrode reaction kinetics KW - sp 2 carbon electrodes KW - response KW - scan rates N2 - The electrochemical properties of two commercial (Condias, Sumitomo) boron-doped diamond thin-film electrodes were compared with those of two types of boron-doped diamond thin film deposited in our laboratory (microcrystalline, nanocrystalline). Scanning electron microscopy and Raman spectroscopy were used to characterize the electrode morphology and microstructure, respectively. Cyclic voltammetry was used to study the electrochemical response, with five different redox systems serving as probes (Fe(CN)63-/4-, Ru(NH3)63+/2+, IrCl62-/3-, 4-methylcatechol, Fe3+/2+). The response for the different systems was quite reproducibile from electrode type to type and from film to film for electrodes of the same type. For all five redox systems, the forward reaction peak current varied linearly with the scan rate1/2 (ν), indicative of electrode reaction kinetics controlled by mass transport (semi-infinite linear diffusion) of the reactant. Apparent heterogeneous electron-transfer rate constants, k°app, for all five redox systems were determined from ΔEp−ν experimental data, according to the method described by Nicholson (Nicholson, R. S. Anal. Chem. 1965, 37, 1351.). The rate constants were also verified through digital simulation (DigiSim 3.03) of the voltammetric i−E curves at different scan rates. Good fits between the experimental and simulated voltammograms were found for scan rates up to 50 V/s. k°app values of 0.05−0.5 cm/s were observed for Fe(CN)63-/4-, Ru(NH3)63+/2+, and IrCl62-/3- without any extensive electrode pretreatment (e.g., polishing). Lower k°app values of 10-4−10-6 cm/s were found for 4-methylcatechol and Fe3+/2+. The voltammetric responses for Fe(CN)63-/4- and Ru(NH3)63+/2+ were also examined at all four electrode types at two different solution pH (1.90, 7.35). Since the hydrogen-terminated diamond surfaces contain few, if any, ionizable carbon−oxygen functionalities (e.g., carboxylic acid, pKa ∼4.5), the ΔEp, ipox, and ipred values for the two systems were, for the most part, unaffected by the solution pH. This is in contrast to the typical behavior of oxygenated, sp2 carbon electrodes, such as glassy carbon. ER -