10.1021/ac301940n.s001 Alexey Shvarev Alexey Shvarev Bastien Neel Bastien Neel Eric Bakker Eric Bakker Detection Limits of Thin Layer Coulometry with Ionophore Based Ion-Selective Membranes American Chemical Society 2012 layer coulometric sensors detection limit flux 50 μ m diameter Thin Layer Coulometry membrane 10 μ M sodium background presence 10 μ M potassium PVDF Ag concentration calibration 2012-09-18 00:00:00 Journal contribution https://acs.figshare.com/articles/journal_contribution/Detection_Limits_of_Thin_Layer_Coulometry_with_Ionophore_Based_Ion_Selective_Membranes/2485966 We report here on a significant improvement in lowering the low detection limit of thin layer coulometric sensors based on liquid ion-selective membranes, using a potassium-selective system as a model example. Various possible processes that may result in an elevated residual current reading after electrolysis were eliminated. Self-dissolution of AgCl on the Ag/AgCl inner element may result in a residual ion flux that could adversely affect the lower detection limit. It was here replaced with an Ag/AgI inner pseudoreference electrode where the self-dissolution equilibrium is largely suppressed. Possible residual currents originating from a direct contact between inner element and ion-selective membranes were eliminated by introducing an inert PVDF separator of 50 μm diameter that was coiled around the inner element by a custom-made instrument. Finally, the influence of electrolyte fluxes from the outer solution across the membrane into the sample was evaluated by altering its lipophilic nature and reducing its concentration. It was found that this last effect is most likely responsible for the observed residual current for the potassium-selective membranes studied here. For the optimized conditions, the calibration curves demonstrated a near zero intercept, thereby paving the way to the coulometric calibration-free sensing of ionic species. A linear calibration curve for the coulometric cell with valinomycin potassium-selective membrane was obtained in the range of 100 nM to 10 μM potassium in the presence of a 10 μM sodium background. In the presence of a higher (100 μM) concentration of sodium, a reliable detection of 1–100 μM of potassium was achieved.